 |
After removing the cartridges put a piece of tape
over the bottom ink port. This will stop any air
from entering the cartridge when you are priming it
from the top. |
 |
Remove the plug near the hose on top of the
cartridge. This is where you will re-prime the cartridge.
|
 |
Insert the tip of the syringe into this hole and
pull up on the plunger. Keep doing this until you
see 1 mls of ink in the syringe. Then replace the
plug. See photo |
 |
Install the cartridges back into the printer and do a cleaning
then a nozzle check to see if all the nozzles are working. |
 |
After doing three cleanings the nozzle check was perfect.
Never do more then three cleaning at a time. Let it sit for
about 2 or 3 hours then you can clean again. |
 |
Our Purge hose and syringe set is used to prime the printhead
should the printhead run empty.
Buy
Now
|
