-
DTF Adhesive Powder (White) 1LB
-
Revolutionary DTF Powder - works with all DTF printers on the market! The process of heat transfer of textile ink to the film can be done on a variety of fabrics such as cotton and polyester.
-
Transfer adhesive powder is applied to DTF prints after printing.
-
When printing using a DTF you will first need to print to the DTF film. Then, add DTF powder to cover the print before curing. Wear protective masks when operating your DTF equipment and processes and operate in a well ventilated room with a filtration system
-
Medium adhesive is our favorite. It's a nice balance between fine and course.
-
Heat at 210 degrees for 2-3 minutes until powder is melted.
-
Transfer time is 15-20 seconds at 300-325 F with low melting point
Curing and heat pressing DTF transfers should be done in a ventilated room with good air flow. Breathing in fumes can be hazardous to your health.
